Free models · Game-ready GLB
Buildings
Every realistic building below is a self-contained .glb under 25 MB that drops into three.js, Blender, Godot, Unity and Unreal, free to use and modify in commercial projects without attribution.
Load one straight from its CDN URL with a plain GLTFLoader, or take a whole buildings set from the packs.
1,418 free GLB models
AnimatedSite welfare unit (Demolition and Site Clearance)
The same cabin as the welfare unit: a blue clad body with a yellow banded door, two windows and a mess room end, on stacked blocks with a water butt and a waste drum plumbed at the back, where the crew takes its breaks.
AnimatedSite cabin on blocks (Demolition and Site Clearance)
Portable site cabin 6 m by 2.4 m standing on stacked concrete blocks: a cream clad body on steel skids with a charcoal base rail, three sliding windows, a blue banded door up two steps, lifting eyes at the corners and a blank notice plate.
Demolition wall section, down to rubble (Demolition and Site Clearance)
The same 4 m bay after the wall is down: a 500 mm stub of brickwork on the footing with the broken face showing, a heap of graded masonry rubble across the bay and two lengths of bent rebar lying in it, ready for the loader.
Floor slab section with rebar showing, 4 m (Demolition and Site Clearance)
Broken reinforced floor slab 4 m square and 220 mm thick: a saw cut edge on two sides, a ragged broken edge on the others with the reinforcement mesh bent up out of it, a screed patch lifted clear and ground ports on all four sides.
Demolition wall section, breached (Demolition and Site Clearance)
The same wall section taken back by the machine: a full height pier at one end, a ragged stepped edge of brick teeth, a breach right through the middle at ground level and a broken lintel hanging over it, with bent rebar tails showing in the concrete.
Demolition wall section, intact (Demolition and Site Clearance)
Intact masonry wall section 4 m wide, 3.2 m tall and 320 mm thick: brickwork with proud courses, a concrete lintel over a blocked opening, a cream plaster patch on the inner face and a stub of floor beam left in the pocket, with side ports at 1.4 m so a facade runs on.
Terminal lift and stair core (Ferry Terminal and Harbour Crossing)
Two storey circulation core 3.4 m square and 5.2 m tall: a glazed lift shaft with a charcoal car and blue call panels, a steel dogleg stair with a landing and handrails, and a grey machine housing on top.
AnimatedTerminal toilets door module (Ferry Terminal and Harbour Crossing)
Washroom entrance module 2.6 m wide and 3 m tall: a grey lined wall with two charcoal doors that swing, blue pictogram plates over them, a lit sign box above and a yellow cleaning in progress board beside.
Terminal roof section, 4 m (Ferry Terminal and Harbour Crossing)
Flat terminal roof cassette 4 m square and 0.42 m deep: a steel deck on charcoal ribs with a grey upstand, a blue fascia band and a rooflight, for roofing a concourse built from facade bays.
AnimatedTerminal entrance bay with sliding doors (Ferry Terminal and Harbour Crossing)
The same 4 m facade module as an entrance: a 2.4 m opening with two glazed leaves that slide apart into the side glazing, a charcoal head box with the operator above them and a yellow threshold strip in the floor.
Terminal facade bay, 4 m (Ferry Terminal and Harbour Crossing)
Glazed terminal facade module 4 m wide and 3.6 m to the eaves: a concrete cill, full height glazing in charcoal mullions, a blue spandrel band under a grey head and a steel eaves flashing. Ports at both ends so a frontage repeats.
Marshalling staff hut (Ferry Terminal and Harbour Crossing)
Yard supervisor's cabin 2.6 m square: a grey clad box on a steel skid with a glazed front, a blue door with a step, a hi vis yellow band round the eaves, a small canopy and a radio aerial.
Check in booth run, three lanes (Ferry Terminal and Harbour Crossing)
Ferry check in island 10 m long: three glazed booths on a raised kerb under a charcoal canopy on steel columns, each with a blue counter shelf, a lit sign box and a card reader on a post facing the driver's window.
Foot passenger gangway tower (Ferry Terminal and Harbour Crossing)
Boarding tower 8.4 m tall with a covered gangway arm: a braced steel frame clad in blue panels with a glazed stair well, a charcoal roofed walkway 8 m out toward the ship at 5.6 m, and a raking strut under its outer end.
AnimatedExercise paddock gate, 1.5 m (Boarding Kennels and Cattery)
The same 1.5 m paddock panel built as a gate: a braced timber leaf with mesh behind it, two charcoal hinges, a drop latch and a blue marker plate, hung between the posts and ported the same way.
Exercise paddock fence panel, 1.5 m (Boarding Kennels and Cattery)
Timber post and rail paddock panel 1.5 m wide and 1.25 m tall with three rails, galvanised mesh behind them on a 180 mm pitch, charcoal post caps and bolted feet, ported on both edges so panels run round a paddock.
AnimatedIsolation pen module with warning sign (Boarding Kennels and Cattery)
Isolation pen on the same 1.5 m grid, set apart from the blocks: the bay shell with a solid cream door and a glazed viewport, a red warning plate over the head beam, a red band on the dividing wall, a disinfectant foot tray at the threshold and a hand gel dispenser by the jamb.
AnimatedCattery pen door with viewing panel (Boarding Kennels and Cattery)
Cattery pen door 1.32 m wide and 1.9 m tall: a steel frame with mesh over the top, a glazed viewing panel at eye level, a green lower panel, a stainless handle and a safety catch, hung on a stile post and swinging out into the corridor.
AnimatedCat flap panel between pen and run, 1.5 m (Boarding Kennels and Cattery)
Painted block panel 1.5 m wide and 2.1 m tall with a framed cat flap through the bottom: a stainless surround, a cream flap on a head hinge with a green kick bar, a green band at hand height and run ports on both edges.
Cattery pen module with shelf ladder, 1.5 m (Boarding Kennels and Cattery)
Cattery pen 1.5 m wide, 2 m deep and 2.1 m to the roof: a painted block dividing wall on its left carrying a three step shelf ladder with green pads and a ramp, a timber sleeping box on the top shelf, a green threshold under the door head and an open back onto the run.
AnimatedOutdoor run gate panel, 1.5 m (Boarding Kennels and Cattery)
The same 1.5 m run panel built as a gate: a mesh leaf on two hinges with an orange kick panel, a mid rail and a charcoal drop latch, hung in the posted frame and ported the same way so it laces into a run of panels.
Outdoor run roof section, 1.5 m (Boarding Kennels and Cattery)
Clear roof module 1.5 m square: a galvanised frame with two purlins, a translucent sheet over it and a blue fascia along the front edge, ported on both sides so sections lay end to end over a row of runs.
AnimatedKennel gate with latch (Boarding Kennels and Cattery)
Galvanised mesh kennel gate 1.32 m wide and 1.75 m tall: a welded frame with a mid rail and mesh infill, a blue kick panel across the bottom, two hinges on a steel stile post and a charcoal drop latch with a thumb lever, swinging out into the corridor.
Outdoor run mesh panel, 1.5 m (Boarding Kennels and Cattery)
Galvanised run panel 1.5 m wide and 1.85 m tall: two square posts on bolted feet with charcoal caps, a top and bottom rail, welded mesh infill on a 150 mm pitch and an orange kick strip along the bottom, with edge ports for laying a run of them.