3D Assets
@3dassets
Large Acacia Tree (Safari Camp and Bush Lodge)
A 7 m flat topped acacia with a heavy trunk, three rising limbs and a canopy 8 m across, big enough to put the dining table under. Static geometry; no wind animation.
Small Acacia Tree (Safari Camp and Bush Lodge)
A 4.2 m flat topped acacia: a tapered trunk, three limbs and a wide browsed canopy with a lower side crown, the silhouette the savanna is read by. Static geometry; no wind animation.
Pole and Wire Fence Section (Safari Camp and Bush Lodge)
A 2.4 m fence bay: two timber poles 1.25 m high with capped tops, three strained wires and one diagonal stay. Chains end to end on the start and end ports and meets the camp gate on the same ports. Static geometry: the wires are solid rods.
AnimatedCamp Gate with Blank Sign Board (Safari Camp and Bush Lodge)
A 3.6 m camp entrance: two heavy timber posts under a lintel, a hanging sign board left blank on both faces to letter, and a 2.5 m braced gate hung on the left post. The gate is one node and swings on the clip. Meets the pole and wire fence on the same ports.
Boma Thorn Brush Fence Section (Safari Camp and Bush Lodge)
A 2 m run of cut thorn brush piled 1.5 m high between two stakes, the branches sticking out of it the way a boma is built. Chains end to end on the start and end ports. Static geometry.
Dry Riverbed Module (Safari Camp and Bush Lodge)
A 6 m square of sand river: a 3.0 m bed of pale sand between two cut banks, scattered with rounded stones, a washed down dead branch and grass on the bank edges. Shares the ground module ports.
Water Hole Edge Module (Safari Camp and Bush Lodge)
A 6 m ground module with a 3.6 m pan sunk into it: a churned mud rim, a flat sheet of green standing water, boulders round the lip and grass on the approach. The water is a flat plane and does not move: a surface needs a shader. Shares the ground ports.
Bush Track Module (Safari Camp and Bush Lodge)
A 6 m square of bush track: two wheel ruts 0.55 m wide worn 40 mm into the dust on a 1.7 m gauge, a strip of dry grass growing up the middle and verges either side. Shares the ground module ports, so a track runs through a tiled plot.
Savanna Ground Module, Dust (Safari Camp and Bush Lodge)
A 6 m square of bare red savanna dust 0.12 m thick, with five flat patches of low scrub and a few embedded stones. Edge ports on all four sides tile it into a continuous ground with the track, riverbed and water hole modules.
Savanna Ground Module, Dry Grass (Safari Camp and Bush Lodge)
The same 6 m ground module in the second tone: bleached dry grass instead of bare dust, for laying a patchwork of the two across a plot. The geometry is unchanged.
AnimatedSpotting Scope on a Tripod (Safari Camp and Bush Lodge)
A 1.45 m spotting scope on a timber tripod: a straight body with an objective bell, an eyepiece, a focus wheel and a pan arm. The scope and head are one node and pan on the clip; the focus wheel does not turn.
Field Desk with Binoculars and Map (Safari Camp and Bush Lodge)
A 1.3 by 0.66 m folding timber field desk with a pair of binoculars, a notebook, a pen tray and a map sheet laid out on it. The map is abstract: blocks and a single track line, no real place and no lettering. Static geometry.
Rifle Case Rack with Closed Cases (Safari Camp and Bush Lodge)
A 1.5 by 1.35 m timber rack carrying four closed, latched hard cases on two shelves, as a camp store stands between drives. The cases are plain boxes with catches and a handle; none is open and no contents are modelled. A blank tally card hangs on the frame.
AnimatedCamera on a Tripod (Safari Camp and Bush Lodge)
A 1.65 m camera tripod with braced legs, a pan head and a generic long lens camera on it. The head, arm and camera are one node and pan on the clip; the legs do not extend.
Camp Radio Set on a Table (Safari Camp and Bush Lodge)
A 1.1 by 0.6 m timber table with a boxed HF transceiver on it: speaker grille, two dials, a handset on its cradle, a clamped whip aerial and a blank log sheet beside it. No lettering or markings anywhere. Static geometry.
Spare Wheel (Safari Camp and Bush Lodge)
A 0.84 m spare wheel on a dished steel rim, standing on its tread. Matches the game drive vehicle's wheels. Static geometry.
AnimatedOpen Game Drive Vehicle (Safari Camp and Bush Lodge)
A 4.9 m open sided game viewing vehicle: a blank panelled olive body, an open windscreen frame, three stepped bench rows under two roll hoops, a rear step and four 0.84 m wheels. Invented shapes, no marque or livery. The wheels are nodes on their axles and roll on the clip.
Jerrycan Rack (Safari Camp and Bush Lodge)
A 1.35 m steel rack holding three 20 litre jerrycans on a raised tray, 0.72 m to the top rail. Cans are plain pressed shapes with cap and handle, no markings of any kind. Static geometry.
Header Tank on Timber Stand (Safari Camp and Bush Lodge)
A 1.0 m galvanised header tank on a braced timber stand 2.6 m high, with a hatch on top and a fall pipe down one leg, which is how a camp gets pressure to its showers. Static geometry; no water is modelled.
AnimatedSkid Mounted Water Bowser (Safari Camp and Bush Lodge)
A 2.2 m water bowser: a 1.1 m diameter tank in two steel cradles on a towable skid with a hitch, a filler hatch on top and an outlet with a gate tap at the back. The tap handle is one node and turns on the clip; the water is not modelled.
AnimatedCamp Battery Box (Safari Camp and Bush Lodge)
A 0.9 by 0.6 m vented steel battery box on a timber pallet base, 0.58 m high, with side handles, a cable gland on the front and a lid hinged along the back. The lid is one node and lifts on the clip.
Solar Panel on Ground Frame (Safari Camp and Bush Lodge)
A 1.7 by 1 m solar panel on a galvanised ground frame, tilted 24 degrees on four feet, with three busbars across the cell face and a cable run off the low edge. Static geometry: the frame has no tracker.
Storm Lantern Set (Safari Camp and Bush Lodge)
Three galvanised storm lanterns of different sizes standing together, the tallest 0.44 m to the top of its handle, with glass chimneys in warm lamp colour. The glow is emissive material, not a light: the GLB embeds no lights.
Camp Dining Table and Chairs (Safari Camp and Bush Lodge)
A 2.2 by 1.1 m slatted timber dining table 0.76 m high laid with a runner, two lanterns and four plates, with four folding camp chairs round it. Stands under a tree or an awning. Static geometry; the chairs are modelled in place.