Free models · Game-ready GLB
Kit
Every low-poly modern model below is a self-contained .glb under 25 MB that drops into three.js, Blender, Godot, Unity and Unreal, free to use and modify in commercial projects without attribution.
Load one straight from its CDN URL with a plain GLTFLoader, or take a whole themed set from the packs.
492 free GLB models
Tented Safari Camp and Bush Lodge (Safari Camp and Bush Lodge)
A working tented camp on a 42 m square of red savanna. Four canvas guest tents stand along the front with their flaps tied back, each on its own deck with a bed under a net frame, a wash stand and a lantern, linked by a raised walkway to the fire. The lodge front and its open...
Pole and Wire Fence Section (Safari Camp and Bush Lodge)
A 2.4 m fence bay: two timber poles 1.25 m high with capped tops, three strained wires and one diagonal stay. Chains end to end on the start and end ports and meets the camp gate on the same ports. Static geometry: the wires are solid rods.
AnimatedCamp Gate with Blank Sign Board (Safari Camp and Bush Lodge)
A 3.6 m camp entrance: two heavy timber posts under a lintel, a hanging sign board left blank on both faces to letter, and a 2.5 m braced gate hung on the left post. The gate is one node and swings on the clip. Meets the pole and wire fence on the same ports.
Boma Thorn Brush Fence Section (Safari Camp and Bush Lodge)
A 2 m run of cut thorn brush piled 1.5 m high between two stakes, the branches sticking out of it the way a boma is built. Chains end to end on the start and end ports. Static geometry.
Dry Riverbed Module (Safari Camp and Bush Lodge)
A 6 m square of sand river: a 3.0 m bed of pale sand between two cut banks, scattered with rounded stones, a washed down dead branch and grass on the bank edges. Shares the ground module ports.
Water Hole Edge Module (Safari Camp and Bush Lodge)
A 6 m ground module with a 3.6 m pan sunk into it: a churned mud rim, a flat sheet of green standing water, boulders round the lip and grass on the approach. The water is a flat plane and does not move: a surface needs a shader. Shares the ground ports.
Bush Track Module (Safari Camp and Bush Lodge)
A 6 m square of bush track: two wheel ruts 0.55 m wide worn 40 mm into the dust on a 1.7 m gauge, a strip of dry grass growing up the middle and verges either side. Shares the ground module ports, so a track runs through a tiled plot.
Savanna Ground Module, Dust (Safari Camp and Bush Lodge)
A 6 m square of bare red savanna dust 0.12 m thick, with five flat patches of low scrub and a few embedded stones. Edge ports on all four sides tile it into a continuous ground with the track, riverbed and water hole modules.
Savanna Ground Module, Dry Grass (Safari Camp and Bush Lodge)
The same 6 m ground module in the second tone: bleached dry grass instead of bare dust, for laying a patchwork of the two across a plot. The geometry is unchanged.
Thatch Roof Section (Safari Camp and Bush Lodge)
A 2.4 m bay of thatched pitch on its purlins and two posts, falling 0.9 m over a 3 m span. Bays chain edge to edge on the start and end ports to roof a boma, a store or a veranda of any length. Static geometry.
Raised Walkway with Rope Handrail (Safari Camp and Bush Lodge)
A 2.4 m bay of raised camp walkway: a 1.1 m boarded deck 0.4 m off the dust on four posts, with two runs of rope handrail through the post heads. Bays chain end to end on the start and end ports to link the tents to the fire. The rope is solid geometry and does not move.
Timber Deck Module (Safari Camp and Bush Lodge)
A 2.4 m square boarded deck on stump piers and two bearers, standing 0.50 m to the walking surface. Edge ports on all four sides tile it out under a tent, a dining area or a lodge front. Static geometry.
Steppe Field Station (Radio Telescope Array and Field Station)
A radio astronomy field station laid on its own ground: a nine metre dish, a six metre dish and a three metre dish across the back of the plot at three different pointings, a fourth mount going up on its traverse rails beside them with the pedestal, counterweight and feed...
Roadside diner and motel stop (Retro Diner and Roadside Motel)
A whole mid century roadside stop, laid out as a place rather than a lineup. The stainless diner car is built from shell modules with a streamlined nose, a glazed window wall and an entrance door, and it is deliberately left open topped with only the chrome roofline band as a...
Confectionery Works Floor (Chocolate and Confectionery Factory)
A 40 by 30 m confectionery works on one epoxy floor, walled at the back and both ends and deliberately left open topped so the whole plant is visible and walkable from above. The bean line runs along the back wall: sack stacks, the roaster, the winnower, the pin mill, the...
Floor Drain Run (Chocolate and Confectionery Factory)
A 2.4 m hygienic floor drain channel with a slotted stainless grate, a kerb on each side and a sump at one end, set into the epoxy floor.
Qc Bench (Chocolate and Confectionery Factory)
A quality control bench with an electronic scale, a stand mounted probe thermometer, a small tray of sample pieces and a blank clipboard board behind.
Taste Counter (Chocolate and Confectionery Factory)
A tasting counter 2.0 m long with three sample trays of chocolate and caramel pieces, a pot of tasting sticks and a napkin box.
AnimatedCoat And Hairnet Locker (Chocolate and Confectionery Factory)
A two door hygiene locker in teal for coats and hairnets, with louvre slots, a centre divider, a folded coat inside and a plain kraft net box on top.
Wash Sink (Chocolate and Confectionery Factory)
A stainless hand wash station with a deep bowl, a knee operated mixer, a splashback, a wall soap box and an undershelf.
Stock Shelf Run (Chocolate and Confectionery Factory)
A 2.4 m three tier storage rack in the plant amber with steel decks and nine blank stock cases on it, for ingredients or finished goods.
AnimatedClean In Place Tank (Chocolate and Confectionery Factory)
A clean in place vessel: a steel tank on three legs with a hinged teal lid, a riser and return pipe, a small pump skid and an abstract gauge plate.
Pallet (Chocolate and Confectionery Factory)
A plain timber pallet 1.20 by 1.00 m with three bearers, nine blocks and six top boards, unstamped and unmarked.
Pallet Stack (Chocolate and Confectionery Factory)
Three stacked pallets carrying eight blank kraft cases under a clear stretch wrap, 1.20 by 1.00 m and 1.90 m high, ready for despatch.