Free models · CC0
Interior
Every stylized model below is a self-contained .glb under 5 MB, released under CC0 1.0 so it can be used and modified in commercial projects without attribution.
Load one straight from its CDN URL with a plain GLTFLoader, or take a whole themed set from the packs.
414 free GLB models
Impact shorts (Snowboard Gear and Freestyle Riders)
Padded impact shorts with hip, tailbone and thigh pads set into a stretch base layer.
Snowboard gloves, pair (Snowboard Gear and Freestyle Riders)
Pair of insulated five-finger snowboard gloves with reinforced palms, wrist leashes and gauntlet cuffs.
Snowboard mittens, pair (Snowboard Gear and Freestyle Riders)
Pair of insulated mittens on the same gauntlet pattern, with a separate thumb and a single finger chamber.
Back protector (Snowboard Gear and Freestyle Riders)
Segmented back protector on a shoulder and waist harness, with articulated spine plates and a kidney belt.
Wrist guards, pair (Snowboard Gear and Freestyle Riders)
Pair of snowboard wrist guards with palm splints, thumb openings and two hook and loop closures each.
Snow goggles (Snowboard Gear and Freestyle Riders)
Cylindrical-lens snow goggles with a foam-backed frame, a vent row and a wide silicone-backed strap.
Snowboard helmet (Snowboard Gear and Freestyle Riders)
In-mould snowboard helmet with a vent row, a rear adjuster dial, removable ear pads and a goggle clip.
Alpine hard boot (Snowboard Gear and Freestyle Riders)
Rigid alpine boot shell with three ratchet buckles, a power strap and a stepped sole for plate bindings.
Board leash (Snowboard Gear and Freestyle Riders)
Coiled board leash with a cuff, a swivel clip and a webbing tail, laid out flat.
Stomp pad (Snowboard Gear and Freestyle Riders)
Moulded stomp pad with a raised spiked grid, backing sheet and rounded corners.
Snowboard soft boot (Snowboard Gear and Freestyle Riders)
Soft snowboard boot with a high padded cuff, a lace panel with a tongue, a heel counter and a lugged rubber sole.
Rear-entry snowboard binding (Snowboard Gear and Freestyle Riders)
Rear-entry binding with a tall reclining highback and a single wide cap strap over the instep.
Step-on snowboard binding (Snowboard Gear and Freestyle Riders)
Low-profile step-on binding with three boot cleats on the baseplate and no straps at all.
Two-strap snowboard binding (Snowboard Gear and Freestyle Riders)
Two-strap binding with a moulded baseplate, mounting disc, heel cup, leaning highback, ankle and toe straps and ratchets.
Baggage Chute (Airport Terminal and Ground Operations)
Make-up hall baggage chute: a deep steel slide trough with amber rub rails and cross cleats, carried on a braced portal frame, fed from a hooded head box at the top and ending in an amber delivery lip over the loading position.
Reclaim Carousel (Airport Terminal and Ground Operations)
Circular flat-plate baggage reclaim carousel: a 4.8 m skirted drum with a stainless kerb, twenty tilted carrier plates, a domed centre island, a screen wall with a real bored injection opening and a double-sided flight display on a mast.
AnimatedPanoramic Lift (Airport Terminal and Ground Operations)
Two floor panoramic passenger lift: a four column glazed shaft with a head deck, a glazed car at the lower landing with a lit ceiling and handrail, centre-opening door leaves on a named pivot and a landing call panel.
Escalator (Airport Terminal and Ground Operations)
Single width escalator rising 3.2 m over a 5.6 m incline: a boxed truss with a saw-tooth step band, comb plates at both landings, glazed balustrades with newel ends and a dark moving handrail.
Travelator Section (Airport Terminal and Ground Operations)
Eight metre level travelator section: a shallow pallet deck with cleat lines and amber comb plates at both ends, glazed balustrades with dark handrails, newel ends and a start-of-run status post.
Departure Board Arrivals (Airport Terminal and Ground Operations)
The same flight information display in the amber header colour, for signing the arrivals hall from the same fabrication.
Information Totem (Airport Terminal and Ground Operations)
Passenger information totem: a slim double-sided blade on a weighted base with a full-height touchscreen, edge light strips and a blank illuminated header cap.
Departure Board (Airport Terminal and Ground Operations)
Free-standing flight information display: a wide dark cabinet on two portal legs with six rows of double-sided screen panels and a coloured header band.
Retail Unit (Airport Terminal and Ground Operations)
Airside retail unit: a boxed shop with a deep signage fascia over a full-width glazed front, a service counter with a till, and two runs of three-tier gondola shelving stocked with blank cartons.
Cafe Unit (Airport Terminal and Ground Operations)
Concourse cafe counter: an amber service bar with a glazed pastry case, espresso machine and till, a back bar with a three panel menu board and a cup shelf, and two bar stools.