3D Assets
@3dassets
Arched Colonnade Bay (Indian Bazaar Street and Temple)
A 4 m bay of covered arcade: two pairs of plaster piers on a stone plinth, a nine voussoir arch turned across each face at 2.1 m springing and a stone roof slab with a projecting cornice over. 2.6 m deep, 3.6 m tall. End ports, so bays butt into a colonnade.
Stepped Doorway (Indian Bazaar Street and Temple)
A house door off the street: three stone steps up to a 1.4 m opening in a plaster wall, a timber frame and reveal, two teal leaves with painted panels and brass handles, a saffron head band and a stone coping. 2.6 m wide, 3.3 m tall. The leaves are shut and static.
Painted Plaster Wall Run (Indian Bazaar Street and Temple)
A 4 m run of street wall: a stone plinth, a plaster face 3.1 m high, a saffron painted skirt and a teal panel on both sides and a stone coping over the top. No lettering anywhere on it. End ports, so runs butt into a frontage of any length.
AnimatedShopfront Bay with Roll Shutter (Indian Bazaar Street and Temple)
A 4 m shop bay closed for the night: a stone plinth, plaster walls, a 2.9 m opening under a steel roll shutter, a crimson canopy on stay rods and a blank painted sign board over it. A timber counter and a three shelf back fitting stand inside. Bays butt along X.
Shopfront Bay Open for Trade (Indian Bazaar Street and Temple)
The same 4 m shop bay trading: the roll shutter is already wound up into the fascia behind the canopy and the 2.9 x 2 m opening is clear, so the counter and the back shelves are in view from the street. The shutter is held open here and does not animate.
Balcony Bay with Jali Screen (Indian Bazaar Street and Temple)
The storey over a shop: a saffron painted front with a pierced jali screen in a 2.1 m opening, a stone balcony on two brackets with a turned teal balustrade, a drying rail with two cloths on it and a parapet round the flat roof. Sits on a shopfront bay at 3.9 m.
Corner Building Block (Indian Bazaar Street and Temple)
A two storey corner plot, 5 x 5 m and 7.4 m tall: plaster over a stone plinth with the street corner chamfered off, a shuttered shop on each face, a teal entrance door on the chamfer with a balcony over it, jali screened upper windows and a parapet round the roof.
Stone Paving Module (Indian Bazaar Street and Temple)
A 4 x 4 m stone paved yard tile, laid to the same 240 mm datum as the footway: a bed with sixteen flags on it in two greys so the joints read. Four edge ports, for a temple forecourt, a compound yard or a widened pavement.
Street Road Module (Indian Bazaar Street and Temple)
A 4 x 4 m tarmac road tile: a 120 mm charcoal slab with a broken centre line down it and two paler patches of repair. Four edge ports, so tiles butt into a carriageway of any length or width.
Pavement Module (Indian Bazaar Street and Temple)
A 4 m length of raised footway: a 140 mm kerb along the road edge, a stone footway behind it and six flagstones laid on top so the joints read. 2.4 m deep, and the shop plinth sits against the back edge. End ports at both ends.
Pavement Drain Module (Indian Bazaar Street and Temple)
The same 4 m footway with a road gully in it: a recess at the kerb line holding a seven bar iron grate in a frame, and the flagstones set back behind it. Same kerb height and the same end ports as the plain pavement, so it drops into a run anywhere.
Cutaway Pressure Hull (Submarine Interior and Control Room)
A 26 m run of pressure hull built from the pack's own 2 m ring sections, shown as a cutaway: every ring forward of the sealed after compartment has the shell above the centre line removed, so the frames and stringers stand as an open cage and all three compartments are looked...
AnimatedTool Locker (Submarine Interior and Control Room)
A 1 m tool locker 1.66 m tall: a shadow board of plain tool silhouettes behind a single door on the door node, and one deep drawer under it on the drawer node. The silhouettes are outlines only, naming no tool and no maker.
AnimatedFresh Water Tank (Submarine Interior and Control Room)
A welded fresh water tank 1.6 by 0.9 m and 1.5 m tall on two saddles with hold down straps: a bolted manhole on the crown, an external sight glass, a flanged draw connection with a stop valve on the wheel-tank node and a blank builder's plate.
Battery Bank (Submarine Interior and Control Room)
A tanked battery bank 2.4 by 1.0 m: a coamed tray holding twelve cells in two rows with vent caps and brass links, a vent trunk with two risers over them, a grating lid to walk on, two meters on the outboard face and an amber warning strip. Static geometry.
AnimatedElectric Motor and Shaft Coupling (Submarine Interior and Control Room)
A 1.4 m ribbed main motor on a bedframe with a terminal box, brush covers and a blank builder's plate, and 1.6 m of tail shaft aft of it through a bearing pedestal and a stuffing box.
Diesel Engine Block (Submarine Interior and Control Room)
A 3.2 m six cylinder diesel: a bedplate on resilient mounts, a crankcase and block, six heads with rocker covers, an exhaust manifold down one flank and a charge air trunk down the other, a blower forward and a flywheel housing aft.
Life Ring on Bracket (Submarine Interior and Control Room)
A 780 mm life ring on a two arm bulkhead bracket, banded in four sectors with a grab line looped round it. Static geometry, and it carries no boat name, port or marking.
AnimatedFolding Step (Submarine Interior and Control Room)
A bulkhead folding step 600 mm wide: a gripped tread on two stays, modelled down and folding flat against its plate on the step node, with a grab rail over it.
Stores Crate, Small (Submarine Interior and Control Room)
The same ironbound timber crate at 0.52 by 0.38 m, for stacking on the larger one or stowing under a bench.
Stores Crate (Submarine Interior and Control Room)
A 0.8 by 0.56 m timber stores crate 540 mm tall with corner irons, top and bottom cleats, two lashing eyes and a plain coloured label strip. Static geometry, and nothing on it is lettered.
AnimatedStores Locker (Submarine Interior and Control Room)
A 920 mm two door stores locker 1.94 m tall with a plinth, a capping rail, drop handles and a plain coloured label strip on each door. Both doors swing on the door-1 and door-2 nodes. The labels are colour only, so nothing is named.
AnimatedStores Locker, Low (Submarine Interior and Control Room)
The same two door stores locker at 920 mm, which is what goes under a bunk run or against a bulkhead where a tall one would not clear the deckhead. Both doors swing on the door-1 and door-2 nodes.
AnimatedFire Hose Reel (Submarine Interior and Control Room)
A 680 mm swinging arm hose reel on a bulkhead plate: a red drum with five turns of hose wound on it turning about Z on the reel node, a nozzle on its clip and a supply valve on the wheel-hose node.